HW7 - shown to the handle of the tap wrench. Show that...

Info iconThis preview shows pages 1–4. Sign up to view the full content.

View Full Document Right Arrow Icon
HW7 Terry Cooke: Cal Poly San Luis Obispo
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Chapter 3, Problem 85 The force P has a magnitude of 250 N and is applied at the end C of a 500-mm rod AC attached to a bracket at A and B . Assuming 30° and 60°, replace P with ( a ) an equivalent force-couple system at B , ( b ) an equivalent system formed by two parallel forces applied at A and B .
Background image of page 2
Chapter 3, Problem 89 While tapping a hole, a machinist applies the horizontal forces
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Background image of page 4
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: shown to the handle of the tap wrench. Show that these forces are equivalent to a single force, and specify, if possible, the point of application of the single force on the handle. Chapter 3, Problem 97 Replace the 150-N force with an equivalent force-couple system at A ....
View Full Document

This note was uploaded on 10/01/2010 for the course ME 211 taught by Professor Staff during the Fall '05 term at Cal Poly.

Page1 / 4

HW7 - shown to the handle of the tap wrench. Show that...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online