# HW10 - C and by two cables AD and AE Determine the tension...

This preview shows pages 1–4. Sign up to view the full content.

HW10 Terry Cooke: Cal Poly San Luis Obispo

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Chapter 4, Problem 95 A 200-mm lever and a 240-mm-diameter pulley are welded to the axle BE that is supported by bearings at C and D . If a 720-N vertical load is applied at A when the lever is horizontal, determine ( a ) the tension in the cord, ( b ) the reactions at C and D . Assume that the bearing at D does not exert any axial thrust.
Chapter 4, Problem 106 A 2.4-m boom is held by a ball-and-socket joint at

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: C and by two cables AD and AE . Determine the tension in each cable and the reaction at C . Chapter 4, Problem 114 The bent rod ABEF is supported by bearings at C and D and by wire AH . Knowing that portion AB of the rod is 250 mm long, determine ( a ) the tension in wire AH , ( b ) the reactions at C and D . Assume that the bearing at D does not exert any axial thrust....
View Full Document

## This note was uploaded on 10/01/2010 for the course ME 211 taught by Professor Staff during the Fall '05 term at Cal Poly.

### Page1 / 4

HW10 - C and by two cables AD and AE Determine the tension...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online