This preview has intentionally blurred sections. Sign up to view the full version.View Full Document
Unformatted text preview: TC 9-524 Chapter 1 INTRODUCTION TO THE MACHINE SHOP GENERAL INFORMATION FORMS, RECORDS, AND REPORTS Accurate records are valuable. Unit officers are responsible for completion of forms, records, and reports. DA Pam 738- 750 lists records, reports, and authorized forms that are normally used for inspection and repair. Properly executed forms authorize and record repair or replacement of materiel. The forms, records, and reports document the work required, follow the progress of the work within the shops, and indicate the status of the material upon completion of repairs. FIELD REPORT OF ACCIDENTS The reports necessary to comply with the requirements of the Army Safety Program are prescribed in detail in AR 385- 40. These reports are required for any accidents involving injury or damage. For a listing of all forms, refer to DA Pam 25-30. Any deficiencies detected in the equipment covered herein should be immediately reported in accordance with DA Pam 738-750. These reports will be submitted as an Equipment Improvement Recommendation on SF 368. DEFINITION OF MACHINE TOOLS Machine tools are power-driven equipment designed to drill, bore, grind, or cut metal or other material. LISTING OF MACHINE TOOLS A complete list of machine tools including specialized machine tools currently authorized for issue is in Component List C 3405/70-lL. SPECIALIZED MACHINE TOOLS In view of the different design and operating features incorporated in specialized machine tools (cylinder boring machines, brake reliners, valve seat grinders. and so forth) by various manufacturers, no attempt has been made to include information pertinent to them in this manual. For complete information on these tools, see pertinent TM 9-3400-, TM 9- 5100-, and TM 9-9000-series technical manuals covering the specific machines. RISK-MANAGEMENT To assure a high degree of safety, no machine -tool is to be used unless the risk management process as outlined below is understood and applied by the user and the supervisor: 1. Identify the potential hazard(s) that the machine tool can generate. 2. Assess the probability and severity of the hazard(s) by utilizing the Risk Assessment Matrix in figure 1-1. Risk acceptance decision authority for the risk levels is as follows: a. Extremely high - CG, TRADOC; DCG, TRADOC; or the Chief of Staff, TRADOC. b. High - Major subordinate commands, installation commanding generals, and school commandants of general officer rank. c. Moderate and low - Delegated to the appropriate level in your unit chain of command. 3. Determine the risk control measures that will eliminate the hazard(s) or reduce the risk. 4. Implement the risk control measures before and during operation of the machine tool to eliminate the hazards or reduce their risks....
View Full Document
This note was uploaded on 10/26/2010 for the course ENGINEERIN MECH221 taught by Professor Wetton during the Spring '10 term at UBC.
- Spring '10