151-M11 Manual Addendum rev 3

151-M11 Manual Addendum rev 3 - M11 Rotational Dynamics I....

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon
1 M11 Rotational Dynamics PHY 151 I. Objectives To test some aspects of rotational dynamics, specifically - the relationship between torque and angular acceleration - the rotational inertia of different objects. II. Equipment - PASCO rotational dynamics apparatus 9279 - mass holder for the rotational dynamics apparatus - 2x 5g, 2x 10g masses - meter stick - stopwatch III. Introduction In preparation for this lab, read M10 part III , M11 part III , and M12 part III in your PHY151 lab manual. IV. Experimental Method To study the physics discussed in M10-12 III, the rotational apparatus is set up as shown in the figure below. A steel disk floats on an air cushion so that it can rotate about its center axis with minimal friction. A mass m drops under the influence of gravity a fixed height ( h = 90 cm), and sets a steel disk into rotational motion via a string. Measure the drop time t for different masses m ( V-1 ), and measure the drop times for different objects attached on to the top of the steel disk ( V-2 and V-3 ). V. Procedure V-1: Use the steel disc of mass M and radius R . Measure and record the mass of the steel disk and the mass holder. Suspend the mass holder of mass m from the end of the string as shown in the figure. Allow m
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 2
This is the end of the preview. Sign up to access the rest of the document.

Page1 / 3

151-M11 Manual Addendum rev 3 - M11 Rotational Dynamics I....

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online