152-EC1 Manual Addendum rev 0

152-EC1 Manual Addendum rev 0 - 152-EC1 Manual Addendum V:...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon
152-EC1 Manual Addendum V: Procedure V-1: No change from the manual V-2: For one of the resistors make a series of measurements of V for various values of I. You must take at least 5 data points. You can vary I by adjusting the output voltage of the power supply. Keep R 1 fixed at 100 Ω. For the report you will plot this data. Remove the resistor you were measuring, and replace it with the Silicon diode. Make sure that the positive electrode of the diode is connected to the positive terminal of the power supply via R 1 . Ask your TA if you do not understand this. Set R 1 to 30 Ω . Record the current I for the following approximate voltage values: V = 0.20, 0.40, 0.50, 0.60, 0.65, 0.70, 0.71, 0.72, 0.73, 0.74, and 0.75 Volts For the report this data will be plotted. V-3through V-5: No change from the manual VI: For the Report VI-1: Tabulate the data taken in V-1. For each resistor measured in V-1calculate the resistance and uncertainty in resistance from your voltage and current measurements. (hint:
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 2
This is the end of the preview. Sign up to access the rest of the document.

Page1 / 2

152-EC1 Manual Addendum rev 0 - 152-EC1 Manual Addendum V:...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online