LAB 111

# LAB 111 - LAB 111 PROJECTILE MOTION Mariam Selevany...

This preview shows pages 1–2. Sign up to view the full content.

LAB 111: PROJECTILE MOTION Mariam Selevany, Mohammed Ahmed, Abdul Wali, Andre Amparo, Alfred Continanza Mr. Chiranjivi Lamsal Physics 111A 9-23-10 Introduction: The purpose of the lab is to predict where a target of given size should be placed in order to be hit by a projectile leaving a table in a horizontal direction. Also, the 2 nd purpose is to measure the range of a projectile leaving table at (measured) angle, and then use this value to predict where the projectile will strike the floor. Procedure: Part 1 -Set up the launcher on an edge of a table and than launch the projectile in a horizontal direction from the edge of the table, and note where it strikes the floor (use carbon paper). -Measure the x and y distances as shown in the figure. -Using the measured values of x and y calculate Vo. -Measure the Height H of the target above the floor. -Calculate the distance D where the target should be placed for the projectile to strike it. Clearly show your calculations of a separate page labeled “calculation sheet”. -Measure the distance D where the projectile actually strikes the target. -Repeat this trial 5 times and for each one record results in a table.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

## This note was uploaded on 11/23/2010 for the course CHEM 305893 taught by Professor Oprychal during the Spring '10 term at NJIT.

### Page1 / 3

LAB 111 - LAB 111 PROJECTILE MOTION Mariam Selevany...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online