New Microsoft Word Document - And the block diagram of this...

Info iconThis preview shows pages 1–3. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: And the block diagram of this RLC device is like this: Figure 1: The RLC Block Diagram The transfer function and the equation for the RLC circuit are: The transfer function: 2 2 2 2 ) ( n n n s s s G ϖ ζϖ ϖ + + = ( 1 ) The natural frequency: LC n 1 2 = ϖ ( 2 ) The damping ratio: L C R 2 = ζ ( 3 ) 4) THE EXPERIMENT In this experiment we firstly set up the circuit, which is given in Figure 1 and we connected the circuit to the oscilloscope that the input is displayed on CH1 and the output is displayed on CH2. Than we determined the step input response by these steps: i) We first switch the waveform to square wave and adjust the frequency to a low value. Then we placed the input signal in the middle of the screen. ii) We changed the R, L and C values to see the effects of each parameter on the system response such as oscillations, steady-state error, etc. after getting a good reasonable step response we stopped changing the R, L and C values. The values for the R, L and C are: R=10 kΩ...
View Full Document

This note was uploaded on 12/03/2010 for the course MECHANICAL 1212 taught by Professor Ümran during the Spring '10 term at Istanbul Technical University.

Page1 / 4

New Microsoft Word Document - And the block diagram of this...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online