reading ma 1957 pg 173 article 8 1 thermal analysis

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: rinting, Addison-Wesley Publishing Co., Inc., Reading, MA, 1957, pg. 134, fig. 6-7. Analysis Type(s): Thermal Analysis (ANTYPE = 0) Element Type(s): 3-D Thermal Solid Elements (SOLID70) Input Listing: vm101.dat Test Case A short solid cylinder is subjected to the surface temperatures shown. Determine the temperature distribution within the cylinder. Figure 101.1 Short Solid Cylinder Problem Sketch Material Properties k = 1.0 Btu/hr-ft-°F Geometric Properties r= = 6 in = 0.5 ft Loading TTop = 40°F TBot = TWall = 0°F Analysis Assumptions and Modeling Notes Since the problem is axisymmetric only a sector (one element wide) is modeled. A small angle Θ=10° is used for approximating the circular boundary with a straight-sided element. Note that circumferential symmetry is automatically ensured due to default adiabatic boundary conditions. POST1 is used to report centerline and midradius temperatures to compare results. Results Comparison Target[1] T, °F (centerline) ANSYS Ratio Node 11 6.8 7.4 1.09 No...
View Full Document

This note was uploaded on 12/09/2010 for the course DEPARTMENT E301 taught by Professor Kulasinghe during the Spring '09 term at University of Peradeniya.

Ask a homework question - tutors are online