This preview shows page 1. Sign up to view the full content.
Unformatted text preview: L1 = j4 Ω
AI = -3 Loading
V = 15 volts at a phaser angle of 30°
I = 5 amps at a phaser angle of -45° Analysis Assumptions and Modeling Notes
A harmonic analysis is run at a frequency of 1/2 π Hz so that the inductor impedance value can be simply input
as 4 ohms. Care must be exercised in assigning the node values to the current controlled current source (CCCS)
to correctly account for the sign on the CCCS gain (AI). ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. 1–472 VM208 Results Comparison
@ Node 4 Target ANSYS Ratio Real Voltage, V 16.44 16.46 1.001 Imag Voltage, V -1.41 -1.41 1.00 ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. 1–473 VM209: Multiple Species Flow Entering a Circular Pipe
Reference: W. M. Kays, M. E. Crawford, Convective Heat and Mass Transfer, 3rd Edition,
McGraw-Hill Book Co., Inc., New York, NY, 1993, pp. 126-134. Analysis Type(s): Multiple Species Analysis (FLOTRAN) Element Type(s): 2-D Fluid-Thermal Elements (FLUID141) Input Listing: vm209.dat Test Case
Flow of two species (A and B), entering a circular pipe is considered. The flow is hydrodynamically developed.
This condition is guaranteed by specifying uniform but dissimilar pressure at the inlet and outlet of the pipe.
Uniform and dissimilar mass fracti...
View Full Document
This note was uploaded on 12/09/2010 for the course DEPARTMENT E301 taught by Professor Kulasinghe during the Spring '09 term at University of Peradeniya.
- Spring '09
- The Land