388 article 45 static plastic analysis antype 0 3 d

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: training its degrees of freedom. The reaction forces at the mass then give the acceleration components. Results Comparison Target ANSYS[1] Ratio ax , ft/sec -11.78 -11.78 1.00 ay , ft/sec2 -5.00 -5.00 1.00 2 ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. 1–294 VM131 Target az , ft/sec2 1. ANSYS[1] Ratio 6.00 6.00 1.00 ax , ay , az are given by the reaction forces at node 1 (FX, FY, FZ respectively). ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. 1–295 VM132: Stress Relaxation of a Tightened Bolt Due to Creep Overview Reference: S. Timoshenko, Strength of Material, Part II, Elementary Theory and Problems, 3rd Edition, D. Van Nostrand Co., Inc., New York, NY, 1956, pg. 531, article 93. Analysis Type(s): Static Analysis (ANTYPE = 0) (with creep properties and initial strain) Element Type(s): 2-D Spar (or Truss) Elements (LINK1) Input Listing: vm132.dat Test Case A bolt of length and cross-sectional area A is tightened to an initial stress σo. The bolt is held for a long period of time t1 at an elevated temperature T...
View Full Document

This note was uploaded on 12/09/2010 for the course DEPARTMENT E301 taught by Professor Kulasinghe during the Spring '09 term at University of Peradeniya.

Ask a homework question - tutors are online