ANSYS varification manual 9

# A slice of 5 degrees is selected the cable length is

This preview shows page 1. Sign up to view the full content.

This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: vm211.dat Test Case A long rubber cylinder is pressed between two rigid plates using a maximum imposed displacement of δmax. Determine the force-deflection response. Figure 211.1 Rubber Cylinder Problem Sketch Material Properties E = 2.82 MPa ν = 0.49967 Mooney-Rivlin Constants: C1 = 0.293 MPa C2 = 0.177 MPa 1. Geometric Properties r = 0.2 m Loading δmax = 0.2 m Real Constant[1] FKN = 8 Applicable to CONTA171, CONTA172, CONTA173, and CONTA174. ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. 1–482 VM211 Analysis Assumptions and Modeling Notes This test case solves the problem of VM201 using the 2-D and 3-D rigid target and contact elements. A plane strain solution is assumed based on the geometry of the problem. Due to geometric and loading symmetry, the analysis can be performed using one quarter of the cross section. All nodes on the left edge (X = 0) are constrained, UX = 0. All nodes on the top edge (y = 0) are coupled in UY. An imposed displacement of -0.1 m acts upon the coupled nodes. This problem is solved in eight different ways. The first four so...
View Full Document

## This note was uploaded on 12/09/2010 for the course DEPARTMENT E301 taught by Professor Kulasinghe during the Spring '09 term at University of Peradeniya.

Ask a homework question - tutors are online