Ansys release 90 002114 sas ip inc cb 986 1 a 75432

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: nt across the piezoceramic for the 1/2 symmetry model. The TEMP and MAG degrees of freedom of SOLID5 are not used in this analysis. Admittance Y is calculated as I/V where I is the current and V is the applied potential. The current I is related to 1 the accumulated charge on the electrode surface as I = jωσQi, where ω is the operating frequency, j is and ΣQi is the summed nodal charge (nodal reaction load). Since the nodal potentials are coupled, only the reaction "load" from the single node where the voltage is applied is required for the calculation. A series of calculations are made between 20 kHz and 54 kHz in POST26, which span the first natural frequency ( ≈ 44 kHz). Results Comparison Target[1] Ratio Y, mmhos @ 20kHz .41 .43 1.047 Y, mmhos @ 35kHz .90 .96 1.063 Y, mmhos @ 42kHz 2.0 2.8 1.400 Y, mmhos @ 45kHz - -1.74 - Y, mmhos @ 50kHz 1–396 ANSYS[2] .39 .32 0.833 ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. VM176 Target[1] Y, mmhos @...
View Full Document

This note was uploaded on 12/09/2010 for the course DEPARTMENT E301 taught by Professor Kulasinghe during the Spring '09 term at University of Peradeniya.

Ask a homework question - tutors are online