Ansys release 90 002114 sas ip inc vm226 figure 2262

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: m Beam height PA = 100 µm2 Capacitor plate area CAP1 = 1 µm Initial gap C3 = 0.885 X 10-5 Transducer capacitance real constant Analysis Assumptions and Modeling Notes The beam is assumed to be pinned at both ends. Furthermore, the analysis uses an unsymmetric matrix. Calculations assume the gap stiffness is much less than the beam stiffness and will not effect the frequency solution. Results Comparison Pre- stress Target ANSYS Ratio Freq1 0.3517E06 0.3517E06 1.000 Freq2 0.1381E07 0.1381E07 1.000 Freq3 0.3097E07 0.3095E07 0.999 ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. 1–516 VM223 Figure 223.1 Freq1 Results Plot Figure 223.2 Freq2 Results Plot ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. 1–517 VM223 Figure 223.3 Freq3 Results Plot 1–518 ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. VM224: Implicit Creep under Biaxial Load Overview Reference: A. A. Becker, T. H. Hyde, Fundamental Test of Creep Behavior, 2nd Edition, NAFEMS...
View Full Document

This note was uploaded on 12/09/2010 for the course DEPARTMENT E301 taught by Professor Kulasinghe during the Spring '09 term at University of Peradeniya.

Ask a homework question - tutors are online