This preview shows page 1. Sign up to view the full content.
Unformatted text preview: Several target points may be used in a test case, so each is identified separately as Target Pointxx (or TP-XX). The
example below shows two target points on a simple 2-D finite element mesh. Solution comparisons between the target solution and the ANSYS solution at target points are listed in the Results
Comparison section. 2–2 ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. Section 2.5: Benchmark Test Case Coverage Index 2.3. Running the Benchmark Test Cases
The benchmark test cases are contained on the installation media. Each test case input file is designed to be
executed in one of two ways:
• Execute the single documented test case input (as shown in the Data Input Listing section for the problem
in this manual; see Appendix B:, Benchmark Input Listings) • Execute all test cases for the problem. The single test case executions are designed to run quickly, with
run times comparable to the larger tests in Chapter 2, “Overview”. Executing all test cases is, in many instances, very time consuming and may require extremely large amount...
View Full Document
This note was uploaded on 12/09/2010 for the course DEPARTMENT E301 taught by Professor Kulasinghe during the Spring '09 term at University of Peradeniya.
- Spring '09
- The Land