Results are obtained from the solution phase and from

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: lem. 4) Figure 37.2 Elongation of a Solid-Bar-Axial Stress Contour Display (SOLID45 Model) 1–92 ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. VM38: Plastic Loading of a Thick-Walled Cylinder Overview Reference: S. Timoshenko, Strength of Material, Part II, Elementary Theory and Problems, 3rd Edition, D. Van Nostrand Co., Inc., New York, NY, 1956, pg. 388, article 70. Analysis Type(s): Static, Plastic Analysis (ANTYPE = 0) Element Type(s): 2-D Structural Solid Elements (PLANE42) 2-D Structural Surface Effect Elements (SURF153) 3-D Structural Solid Elements (SOLID45) 3-D Structural Surface Effect Elements (SURF154) Input Listing: vm38.dat Test Case A long thick-walled cylinder is subjected to an internal pressure p (with no end cap load). Determine the radial stress, σr, and the tangential (hoop) stress, σt, at locations near the inner and outer surfaces of the cylinder for a pressure, pel, just below the yield strength of the material, a fully elastic material condition. Determine the effective (vo...
View Full Document

This note was uploaded on 12/09/2010 for the course DEPARTMENT E301 taught by Professor Kulasinghe during the Spring '09 term at University of Peradeniya.

Ask a homework question - tutors are online