The combin40 gap cannot be used in a reduced

Info iconThis preview shows page 1. Sign up to view the full content.

View Full Document Right Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: ymin of the mass, neglecting the mass of the rod. Figure 80.1 Plastic Response Problem Sketch Material Properties m = 0.0259 kips-sec2/in E = 30 x 103 ksi σyp = 162.9 ksi Geometric Properties = 100 in A = 0.278 in2 Loading F1 = 30 kips (see time history in Figure 80.1: “Plastic Response Problem Sketch”) ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. 1–181 VM80 Analysis Assumptions and Modeling Notes The initial integration time step (0.004/10 = 0.0004 sec) is chosen small enough to allow the initial step change in acceleration to be followed reasonably well. The final integration time step ((0.14-.004)/68 = 0.002 sec) is based on ≈ 1/60 of the period to produce sufficient printout for the theoretical comparison. The final time of 0.14 sec allows slightly more than 1 cycle of vibration to be followed. POST26 is used to extract results from the solution phase. Results Comparison Target ANSYS[1] Ratio ymax, in 0.806 0.804 0.998 Time, sec 0.0669 0.0680 1.016...
View Full Document

{[ snackBarMessage ]}

Ask a homework question - tutors are online