This preview shows page 1. Sign up to view the full content.
Unformatted text preview: pe
name) is used in the /TITLE command. In addition, a character parameter for degrees of freedom is used in the
CP commands and in the macro SOLD.
POST1 is used to obtain the displaced configuration at the end of loading. The maximum shear stress is computed
from the solution results in POST26. In order to be consistent with the reference solution, the maximum shear
stress in a negative direction is observed. Results Comparison
Target ANSYS Ratio VISCO106 Shear Stressmax , psi -48.0 -48.6 1.012 VISCO107 Shear Stressmax , psi -48.0 -48.6 1.012 VISCO108 Shear Stressmax , psi -48.0 -46.1 0.960 Figure 198.2 Typical Element Deformation Display 1–448 ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. VM198 Figure 198.3 Typical Stress vs. Rotation Display ANSYS Verification Manual . ANSYS Release 9.0 . 002114 . © SAS IP, Inc. 1–449 VM199: Viscoplastic Analysis of a Body (Shear Deformation)
Reference: B. Lwo, G. M. Eggert, “An Implicit Stress Update Algorithm...
View Full Document
This note was uploaded on 12/09/2010 for the course DEPARTMENT E301 taught by Professor Kulasinghe during the Spring '09 term at University of Peradeniya.
- Spring '09
- The Land