# BackExam_1 - Name Section Strength of Materials Test#1...

This preview shows pages 1–4. Sign up to view the full content.

Name: ______________________________________ Section: __________ Strength of Materials Test #1 Problem Value Score 1 25 2 25 3 25 4 25 Total: 1. Write your name and section number on all pages. 2. State all your assumptions and present your work in an organized and legible fashion. Neatness Counts, points will be deducted if your work is not neat and properly organized.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Name: ______________________________________ Section: __________ Problem 1: The rigid bar AB shown in Fig. 1 is supported by a steel rod AC having a diameter of 20 mm and an aluminum block having a cross-sectional area of 1800 mm 2 . The 18 mm - diameter pins at A and C are subjected to single shear. If the allowable stress for the steel and aluminum is (_ st ) all = 340 MPa and (_ AL ) all = 35 MPa, respectively, and the allowable shear stress for each pin is _ all = 450 MPa, determine the largest load P that can be applied to the bar. (Disregard the bearing stress near pins A & C).
Name: ______________________________________ Section: __________

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

## This note was uploaded on 12/14/2010 for the course ENGR 2530 taught by Professor Lindaschadlerfeist during the Fall '08 term at Rensselaer Polytechnic Institute.

### Page1 / 9

BackExam_1 - Name Section Strength of Materials Test#1...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online