Lab6MRSP10 - UNIVERSITY OF MISSOURI - COLUMBIA DEPARTMENT...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: UNIVERSITY OF MISSOURI - COLUMBIA DEPARTMENT OF MECHANICAL AND AEROSPACE ENGINEERING MAE 3800 Instrumentation and Measurements Laboratory EXPERIMENT #6 Dynamic characteristics of a DC permanent magnet motor Due: Thursday, April 22 1. Introduction: DC permanent magnet motors are widely used in the control of engineering systems. Obtaining their dynamic characteristics requires a dynamometer and simultaneous measurement of motion (shaft rpm) and force (shaft torque). 1.1 Objective: To use an optical tachometer for shaft speed measurement To learn to calibrate a torque sensor To obtain the torque-speed curves of the DC motor 1.2 Equipment: DC motor with torque sensors and an MR fluid dynamometer. Strain readout units. Photo-diodes and frequency counter. 1.3 Suggested reading: sections 3.14, 3.15 (graphing and curve fitting), 6.15-6-16 (solid-state optical sensors), 7.8- 7.9.1, 7.18.1 (bridge circuits), 12.1-12.8.1 (strain gages), 13.4-5 (elastic load cells) 1.4 Report format You are required to prepare a technical memo addressed to your lab instructor....
View Full Document

This note was uploaded on 01/12/2011 for the course MAE 3800 taught by Professor Feng during the Spring '10 term at Missouri (Mizzou).

Page1 / 4

Lab6MRSP10 - UNIVERSITY OF MISSOURI - COLUMBIA DEPARTMENT...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online