DatasheetA201 - A201 Standard Force Load Sensors FlexiForce...

Physical Properties
Thickness 0.008" (0.208 mm)
Length 7.75" (197 mm),
optional trimmed lengths : 6” (152 mm), 4” (102 mm), or 2” (51mm)
Width 0.55" (14 mm)
Sensing Area 0.375" diameter (9.53 mm)
Connector 3-pin Male Square Pin (center pin is inactive)
Substrate Polyester (ex: Mylar)
Standard Force Ranges (as tested with circuit shown below)
0 - 1 lb. (4.4 N)
0 - 25 lb. (110 N)
0 - 100 lb. (440 N)*
In order to measure forces above 100 lb
(up to 1000 lb), apply a lower drive
voltage and reduce the resistance of the
feedback resistor (1k Ω min.)
Typical Performance Evaluation Conditions
Linearity (Error) < ±5% Line drawn from 0 to 50% load
Repeatability < ±2.5% of full scale Conditioned sensor, 80% of full force applied
Hysteresis < 4.5 % of full scale Conditioned sensor, 80% of full force applied
Drift < 5% per logarithmic time scale Constant load of 25 lb (111 N)
Response Time < 5 μsec