{[ promptMessage ]}

Bookmark it

{[ promptMessage ]}

Lab Report #1

# Lab Report #1 - PACING&HANDCOMPASSTRAVERSE...

This preview shows pages 1–7. Sign up to view the full content.

Mississippi State University Department of Civil Engineering PACING & HAND-COMPASS TRAVERSE CE 2213: Surveying Laboratory Session: Thursday Colin Goostree Plot 3 Date of Survey: 8/26/2010  Date of Submittal: 9/02/2010

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
2 Table of Contents Section Page Table of Contents 2 Objective # Apparatus # Procedure # Results #       Figure 1. Plot # Traverse # Discussion # Conclusion # Field Notes # Sample Calculations # References #
3 Objective The goal of this lab was to determine the length of a triangle through use of paces.  Azimuths where also measured with the use of a compass. Length of paces where  predetermined by walking 100 meters and measuring amount of paces.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
4 Apparatus Compass – Used to measure azimuths between points in plot Range Pole – Pole that sticks in the ground to mark a point in the plot
5 Procedure PACING & HAND-COMPASS TRAVERSE :

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
6 1. Measured azimuth of point E to A 2.
This is the end of the preview. Sign up to access the rest of the document.

{[ snackBarMessage ]}

### Page1 / 16

Lab Report #1 - PACING&HANDCOMPASSTRAVERSE...

This preview shows document pages 1 - 7. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online