Chapter 6 - PART III: Mechanical Properties Chapters:...

Info iconThis preview shows pages 1–15. Sign up to view the full content.

View Full Document Right Arrow Icon
1 PART III: Mechanical Properties Chapters: 6,7,8.
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
3 There are actually 3 chapters devoted to this subject. In chapter 6 we start with an overview of mechanical properties at the macroscopic level. In chapter 7 we look at mechanisms which determine the strength of a material. This involves microscopic characteristics. In chapter 8 we study fracture behavior.
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
4 What you should understand by the end of this chapter How engineering stress and strain are defined. The main states of stress and strain. Elastic deformation of materials. Relationship between elastic response to atomic bonding . Plastic behaviour and ductility in metals What parameters are measured in a tensile test. The concepts of true stress and true strain
Background image of page 4
5 Mechanical Properties Taiwan's Japanese-built 300 km/h 700T series train
Background image of page 5

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
6 Mechanical Properties
Background image of page 6
7 Introduction The vast majority of materials are used to bear and sustain loads . buildings bridges cars space shuttle We need to understand… … how much force a material will withstand without: deflecting too much. deforming permanently. cracking or breaking. … how the mechanical behaviour changes over time due to: high temperature exposure. fatigue. combinations of the above.
Background image of page 7

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
8 Basic Concepts What is a “ mechanical response ”? If you apply forces to an object it can: Move Rotate Deform To eliminate the first two you must apply balanced forces. You can measure deflection and distortion of the material under a load. The actual response depends on the: material. structure and geometry. A material’s response is correlated by: stress ( normalized force ). strain ( normalized deflection ).
Background image of page 8
9 ALS What Parameter Correlates A Material’s Behaviour? If it requires 2 baby elephants to break the lecture table how many elephants would it take to break two tables joined together ? Why and what is the principle? A material’s response is correlated by: stress ( normalized force). strain ( normalized deflection). If a 20 m long bungee cord stretches 6 m when you jump how long will a 30 m cord stretch ?
Background image of page 9

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
10 ALS Why does this man not get hurt?
Background image of page 10
11 Tensile and Compressive Stresses A material’s response is determined by the load per unit area stress . In tension or compression: σ = F / A 0 This is called the engineering stress . The units of stress are N / m 2 = Pa . Typical stresses are expressed in MPa. Canyon Bridge, Los Alamos, NM Ski lift (photo courtesy P.M. Anderson) Cable in tension: & > 0 Strut in compression: & < 0
Background image of page 11

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
12 M M A o 2R F s A c Other States of Stress: Shear Shear stress, τ = F / A 0 Example: a drive shaft
Background image of page 12