Lab7 - 540:304 Manufacturing Processes Laboratory Spring...

Info iconThis preview shows pages 1–3. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: 540:304 Manufacturing Processes Laboratory Spring 2011 Laboratory Report #4 Coordinate Measurement Machine (CMM) and Reverse Engineering by Farrah Vijayan Date 2/24/2011 I. Introduction : This lab required students to use CMM i.e. Coordinated Measurement Machine to measure 36 identical engineering tools. CMM can be manually controlled or computer controlled. There are in total three axes and measurements are determined by a probe attached to the third moving axis of the machine. Probes can be mechanical, optical, laser, or white light, etc. The diameters, the smaller diameter and the length of the shaft were measured. The readings were noted multiple times to get an accurate value for the shaft’s dimensions. Based on these dimensions the three dimensional drawing (Figure 2) is made. II. Experiment Description : The lab involved repetitive measurement of work pieces using CMM. The dimensions L,l,D,d were measured . The objective of the lab was to compare the measurement readings of this instruments by both the tools from previous lab with...
View Full Document

This note was uploaded on 03/24/2011 for the course INDUSTRIAL 540 taught by Professor Albin during the Spring '11 term at Rutgers.

Page1 / 3

Lab7 - 540:304 Manufacturing Processes Laboratory Spring...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online