SapGS03 - Installation and learning guide Saphir 4.00 KAPPA...

Info iconThis preview shows pages 1–3. Sign up to view the full content.

View Full Document Right Arrow Icon
Installation and learning guide Saphir Guided Session # 3• SapGS03-1 Saphir 4.00 © KAPPA Engineering 2005 Doc. V. 4.00.03 • 09-05 Saphir Guided Session # 3 A01 • Introduction It is assumed that you have already studied the guided sessions # 1 and # 2. The following session describes the numerical model. It uses the file SapGS03_FieldMap.bmp, SapGS03_Porosity.txt and SapGS03_Thickness.txt. This session is divided into three sections: B: Building the numerical model. C: Using the numerical model. D: Using the numerical model with other features and graphics. Launch Saphir and create a new project with default settings. B01 • 2D Map Click on the tab “2D Map”. The “Tested well” has been defined in the middle of the default rectangle and the coordinates of the well is at (0,0). Fig B01.1
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Installation and learning guide Saphir Guided Session # 3• SapGS03-2 Saphir 4.00 © KAPPA Engineering 2005 Doc. V. 4.00.03 • 09-05 Double click on the tested well and the well radius can be set and the coordinates can be confirmed at (0,0). The well can be a limited entry type or radial composite. The geometry of the well can be vertical, horizontal or fractured set in the geometry droplist. You enter or load the production of the well under the tab “Production”. The rate history of the tested well can also be loaded through the interpretation page. As the objective of this section is to illustrate the use of the 2D Map only we will not load a production history. In the 2D Map toolbar click on to load the bitmap file SapGS03_FieldMap.bmp. This and all the other 2D Map options are also accessible, and mirrors the toolbar, through the popup menu available with a right click in the 2D Map area. Fig B01.2 Load bitmap The tested well can be moved to PO1 using the mouse. The use of the bitmap is to help you in defining contours, other wells, faults and setting the scale. Define the other vertical wells using the icon. Fractured and horizontal wells can also be defined using the toolbar or the popup menu. Define P03 as a fractured well, click once to set one end of the fracture and click a second time to terminate. The position of the well can be changed interactively afterwards using the mouse. By clicking on the well the fracture length and orientation can again be changed using the mouse. Double clicking on the well allows the specification of exact fracture half length. Double click on each of the wells to change the name in the well dialog to the appropriate well name indicated on the bitmap. In the well dialog the properties of the wells can be changed and the production histories loaded or entered. The sense of the tested well (the well with a “physical” pressure gauge) can be changed to other wells and any wells can be excluded from any consequent model generation or simulation. The next step is to draw the contour of the field. Click on
Background image of page 2
Image of page 3
This is the end of the preview. Sign up to access the rest of the document.

Page1 / 12

SapGS03 - Installation and learning guide Saphir 4.00 KAPPA...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online