Quiz 10 Elect280

Quiz 10 Elect280 - Question 1 4 4 points Electrical...

Info iconThis preview shows pages 1–4. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: Question 1 4 / 4 points Electrical Nonmetallic Tubing (ENT) is permitted to have 90° bends, if tubing is bent __________. by hand Question 2 4 / 4 points ENT is approved to be used in sizes of ________. ½ to 2 inch Question 3 4 / 4 points The maximum number of bends in any one run of ENT is limited to the equivalent of _____. 360° Question 4 4 / 4 points AC Cable is required to be supported at intervals not exceeding ________. 54 inches Question 5 4 / 4 points Where AC Cable is installed in an accessible attic, it is required to be protected around the attic access hole for a minimum of _________. 6 ft. Question 6 4 / 4 points MC Cable is required to be supported at intervals that do not exceed ______. 72 inches Question 7 4 / 4 points The installation of MC Cable near an access hole in an accessible attic is required to comply with _______....
View Full Document

This note was uploaded on 05/07/2011 for the course ELECT na taught by Professor Na during the Spring '11 term at American River.

Page1 / 7

Quiz 10 Elect280 - Question 1 4 4 points Electrical...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online