MIL-STD-188-220B - NOT MEASUREMENT SENSITIVE...

Info iconThis preview shows pages 1–4. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: NOT MEASUREMENT SENSITIVE MIL-STD-188-220B 20 January 1998 SUPERSEDING MIL-STD-188-200A 27 July 1995 MIL-STD-188-220 7 May 1993 DEPARTMENT OF DEFENSE INTERFACE STANDARD DIGITAL MESSAGE TRANSFER DEVICE SUBSYSTEMS AMSC N/A AREA TCSS DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited. MIL-STD-188-220B ii FOREWORD This military standard is approved for use by all Departments and Agencies of the Department of Defense (DoD). It applies to all inter- and intra-Department of Defense (DoD) digital message transfer devices (DMTDs) and command, control, communications, computers and intelligence (C 4 I) systems that exchange information with DMTDs. This standard contains technical parameters for the data communications protocols that support DMTD interoperability. It provides mandatory system standards for planning, engineering, procuring, and using DMTDs in tactical digital communications systems. This standard specifies the lower layer (Physical through Intranet) protocol for interoperability of C 4 I systems over combat net radio (CNR) on the battlefield. This standard provides the information required to pass digital data via CNR on the battlefield. The Preparing Activity (PA) for this standard is USACECOM, ATTN: AMSEL-SE-CD (Mr. E. Robinson), Fort Monmouth, NJ 07703. The custodians for the document are identified in the Defense Standardization Program, "Standardization Directory (SD-1)" under Standardization Area Data Communication Protocol Standards (DCPS). Beneficial comments (recommendations, additions, deletions) and any pertinent data that may be of use in improving this military standard should be addressed to the PA at the above address by using the Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter. MIL-STD-188-220B CONTENTS PARAGRAPH PAGE iii FOREWORD ..................................................................................................................... ii 1. SCOPE ............................................................................................................................ 1-1 1.1 Purpose................................................................................................................ 1-1 1.2 Scope ................................................................................................................... 1-1 1.3 Application guidance........................................................................................... 1-1 1.4 System standards and design............................................................................... 1-1 2. APPLICABLE DOCUMENTS ....................................................................................... 2-1 2.1 General ................................................................................................................ 2-1 2.2 Government documents....................................................................................... 2-1 2.2.1 Specifications, standards, and handbooks ........................................................... 2-1 Specifications, standards, and handbooks ....
View Full Document

This note was uploaded on 05/11/2011 for the course ELECTRONIC 005 taught by Professor Haghbin during the Spring '10 term at Sharif University of Technology.

Page1 / 103

MIL-STD-188-220B - NOT MEASUREMENT SENSITIVE...

This preview shows document pages 1 - 4. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online