Flare Tube Specifications

Flare Tube Specifications - SAE Technical Standards Board...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: SAE Technical Standards Board Rules provide that: This report is published by SAE to advance the state of technical and engineering sciences. The use of this report is entirely voluntary, and its applicability and suitability for any particular use, including any patent infringement arising therefrom, is the sole responsibility of the user. SAE reviews each technical report at least every five years at which time it may be reaffirmed, revised, or cancelled. SAE invites your written comments and suggestions. TO PLACE A DOCUMENT ORDER: (724) 776-4970 FAX: (724) 776-0790 SAE WEB ADDRESS http://www.sae.org Copyright 2000 Society of Automotive Engineers, Inc. All rights reserved. Printed in U.S.A. SURFACE VEHICLE 400 Commonwealth Drive, Warrendale, PA 15096-0001 STANDARD Submitted for recognition as an American National Standard J533 REV. DEC1999 Issued 1947-02 Revised 1999-12 Superseding J533 AUG1996 Flares for Tubing 1. Scope This SAE Standard covers specifications for 37-degree and 45-degree single and double flares for tube ends intended for use with 37-degree flared tube fittings and 45-degree flared or inverted flared tube fittings, respectively. 2. References 2.1 Applicable Publications The following publications form a part of this specification to the extent specified herein. Unless otherwise indicated, the latest issue of SAE publications shall apply. 2.1.1 SAE PUBLICATIONSAvailable from SAE, 400 Commonwealth Drive, Warrendale, PA 15096-0001. SAE J514Hydraulic Tube Fittings SAE TSB 003Rules for Use of SI (Metric) Units 3. General Specifications 3.1 Dimensions Dimensions in this document are based on and, unless designated otherwise, are specified in metric units. 3.1.1 Single and double 45-degree flares shall conform to the dimensions specified in Figure 1 and Table 1. 3.1.2 Single and double 37-degree flares shall conform to the dimensions specified in Figure 2 and Table 2. 3.1.3 Optional configurations for single 37-degree flares are specified in Figure 3 and Table 2. These configurations provide extended length of seal contact surface and are recommended for tube wall thickness exceeding E-Table 2. 3.1.4 The following general specifications supplement the dimensional data with respect to unspecified detail and apply to both 37-degree and 45-degree flares for tubing. SAE J533 Revised DEC1999...
View Full Document

This note was uploaded on 06/10/2011 for the course EMA 7414 taught by Professor Mecholsky during the Spring '11 term at University of Florida.

Page1 / 6

Flare Tube Specifications - SAE Technical Standards Board...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online