Final Project Rev5

# Final Project Rev5 - Chemical Engineering Department...

This preview shows pages 1–3. Sign up to view the full content.

Chemical Engineering Department University of Florida ECH 4323L REVISED VERSION FINAL PROJECT COMPUTER SIMULATION STUDIES OF PID CONTROL LOOP DYNAMICS USING SIMULINK Student Name:_______________________________ 1.0 Create a SIMULINK program as illustrated in the figure below, that carries out a computer simulation of a closed-loop system consisting of a first-order plus dead time process y ( s ) = K τ s + 1 e - θ s u ( s ) + d ( s ) where d ( s ) is a disturbance signal, and a standard PID controller with transfer function u ( s ) = K c 1 + 1 I s + D s e ( s ) where e ( s ) = r ( s ) - y ( s ) is the feedback error. 1.1 Consider the case where the process parameters are K = 2 , = 1, and = 5 . 1.1.1 Tune the controller for P-only servo-performance using the following tuning techniques: (a) the Ziegler-Nichols process reaction curve method, and (b) the © Oscar D. Crisalle 1997-2011

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
ECH 4323L Final Project 2 Cohen-and-Coon method. Report the values of the controller parameters for (a)-(b) in a table . Carry out a servo test (unit-step set-point change, zero disturbance) for each one of the cases (a) and (b). Create a graph consisting of two plots in one page. The top plot should show the set point and each of the two servo responses as a function of time, and the bottom plot should display each of the input-signals as a function of time. Write a brief paragraph describing which controller tuning is more aggressive, and whether offset is fully eliminated. Notes : - Use different line types for each of curve in a given plot. Include a legend when the plot has one more than curve. - The title of the top plot should read “FINAL PROJECT, Problem 1.1.1”, followed by your name. Hint 1 : Use the MATLAB commands subplot(121), subplot(122), grid, xlabel, ylabel, axis, and legend . Hint 2 : When using the SIMULINK sink entitled “ To Workspace ”, make sure to double-click on the sink and select the Save Format as Array . Then click on the Apply button. 1.1.2
This is the end of the preview. Sign up to access the rest of the document.

## This note was uploaded on 07/14/2011 for the course ECH 4323 taught by Professor Crissale during the Spring '10 term at University of Florida.

### Page1 / 6

Final Project Rev5 - Chemical Engineering Department...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online