Plastics Extrusion 1997

Plastics Extrusion 1997 - EMA 4666C POLYMER PROCESSING...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon
EMA 4666C POLYMER PROCESSING LABORATORY PLASTICS EXTRUSION PURPOSE: To get "hands on" experience on the extrusion process and learn how the extruder works. Also, to learn how processing parameters and additives affect the thermomechanical properties of thermoplastic polymers. MATERIALS: Three grades of polypropylene in pelletized form: 1. Stabilized PP, MFI=2.0 2. Stabilized PP, MFI=18.0 3. Unstabilized PP, MFI=2.0 EQUIPMENT: 1" screw KL-100 extruder, take-up equipment, stop watch, tape, balance, and gloves PROCEDURE: 1. Heat the barrel and die recommended temperatures and allow the barrel to "soak" at this temperature for at least ten minutes after the temperature reaches the desired level. 2. Turn on the extruder at the lowest speed setting. Never adjust the motor speed unless the motor is running. 3. Pour the material into the hopper (a few pellets at a time) until the material flows smoothly out of the die. 4. Fill the hopper to what ever level you wish once you are satisfied that material is following
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 2
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 07/17/2011 for the course EMA 4666c taught by Professor Brennan during the Spring '08 term at University of Florida.

Page1 / 2

Plastics Extrusion 1997 - EMA 4666C POLYMER PROCESSING...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online