Lecture 1 Scales and Ratios

Lecture 1 Scales and Ratios - Standard Drawing Scales and...

Info iconThis preview shows pages 1–8. Sign up to view the full content.

View Full Document Right Arrow Icon
1 Standard Drawing Scales and Ratios CGN 2328 Technical Drawing and Visualization
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
2 Standard Scales Used to measure distances on any scaled drawing Triangular scales are common because they offer the user a combination of several scales In this class and most likely in your job, you will use the Engineering Scale and the Architectural Scale
Background image of page 2
Triangles CGN2328 - Dr. Najafi - Lecture CGN 2328 Lecture 2 - Dr. Najafi 3 Triangles can be used to find a combination of many angles. The following combinations of 30°-60°-90° triangle and the 45°-45°-90° triangle provide measurements in 15° increments.
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
4 Engineering Scale Each inch is divided into decimal increments Labels 10, 20, 30, 40, 50, 60 on the edges indicate the scale being used Always written as 1”=X’ or 1”=X” The 10 Scale is your True Length Scale 1 inch is divided into 10 divisions. On the 30 Scale, 1true inch is divided into 30 equal divisions
Background image of page 4
5 Engineering Scale Notation: 1” = X units , where X can be expressed in inches, feet, or miles.
Background image of page 5

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
6 Engineering Scale Example Using scale of 1”=3’, find 3.5ft 3.5ft
Background image of page 6
7 Engineering Scale Example Using scale of 1”=50’, find 115’ 115’
Background image of page 7

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 8
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 08/04/2011 for the course CGN 2328 taught by Professor Najafi during the Summer '08 term at University of Florida.

Page1 / 20

Lecture 1 Scales and Ratios - Standard Drawing Scales and...

This preview shows document pages 1 - 8. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online