config-cat-switches-polycom 7936

config-cat-switches-polycom 7936 - Configuring Catalyst...

Info iconThis preview shows pages 1–3. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: Configuring Catalyst Switches for Polycom Conference Phones Document ID: 97229 Introduction Prerequisites Requirements Components Used Related Products Conventions Background Information Configure Network Diagram Cisco IOS Configurations CatOS Configurations Verify Troubleshoot Spanning Tree Loop due to Polycom IP Phones NetPro Discussion Forums - Featured Conversations Related Information Introduction This document provides sample configurations on Catalyst switches in order to connect to Polycom IP Conference Station 7935/7936 and Polycom SoundPoint IP 430. This document does not include power inline and quality of service (QoS) configurations. Prerequisites Requirements Ensure that you meet these requirements before you attempt this configuration: IP Phone Configuration Refer to Quick Start Guide Cisco IP Conference Station 7935 or Cisco Unified IP Conference Station 7936 Phone Guide for more information. Virtual LAN Configuration Refer to Virtual LANs/VLAN Trunking Protocol (VLANs/VTP) - Introduction for more information. Components Used The information in this document is based on the Cisco Catalyst 6500 Series Switch with Supervisor Engine 720 and running Cisco IOS Software Release 12.2(18)SXD6 and Cisco Catalyst 6500 Series Switch with Supervisor Engine 2 and running Cisco CatOS Software Release 8.4(4). The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command. Related Products This configuration can also be used with Cisco Catalyst Switches that run Cisco IOS Software, except Cisco 2900XL and 3500XL series. The CatOS configurations can be used with any Cisco Catalyst Switches that run Catalyst OS Software. Conventions Refer to the Cisco Technical Tips Conventions for more information on document conventions. Background Information This document explains the configuration of the switches that connect the PCs and IP phone Polycom SoundPoint IP 430 on a switch port. This document also explains the configuration of the switches that connect to a Polycom IP Conference Station 7935/7936 switch port. The Polycom IP Conference Station 7935/7936 has a single 10/100BaseTx Ethernet LAN connection to the network through an RJ-45 cable interface and unlike the other Cisco Unified IP phones 7900 Series, it does not have a 10/100BaseTx Ethernet LAN connection in order to connect to a PC. Due to the absence of the provision to connect to a PC with the 10/100BaseTx Ethernet LAN connection on the Cisco 7935/7936 IP Conference Phone, the concept of a voice or auxiliary VLAN does not directly apply and can cause problems. The single 10/100BaseTx Ethernet LAN connection that the Cisco IP Conference Station 7935/7936 has is used in order to connect this device to a switch port. Since this connection carries traffic for only the voice, the switch port should belong to a single VLAN.traffic for only the voice, the switch port should belong to a single VLAN....
View Full Document

This note was uploaded on 08/08/2011 for the course CISCO 1124 taught by Professor Jack during the Spring '11 term at American International.

Page1 / 7

config-cat-switches-polycom 7936 - Configuring Catalyst...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online