File Assignment2.pdf

# File Assignment2.pdf - ASSIGNMENT NO.2 Assignment problem...

This preview shows pages 1–2. Sign up to view the full content.

ASSIGNMENT NO.2 Assignment problem #1 (20 out of 100) A bar ABC of length L consists of two parts of equal lengths but different diameters. Segment AB has diameter d 1 =100mm and segment BC has diameter d 2 =60mm. Both segments have length L/ 2=0.6m. A longitudinal hole of diameter d is drilled through segment AB for one-half of its length (distance L/ 4=0.3m). The bar is made of plastic having modulus of elasticity E =4.0GPa. Compressive loads P =110kN act at the ends of the bar. If the shortening of the bar is limited to 8mm, what is the maximum allowable diameter d max of the hole? Assignment problem #2 (20 out of 100) A uniform bar AB of weight W = 125N is supported by two springs, as shown in the figure. The spring on the left has stiffness 1 300 k = N/m and the natural length L 1 =250mm. The corresponding quantities for the spring on the right are 2 400 k = N/m and L 2 =200mm. The distance between the springs is L =350mm, and the spring on the right is suspended from a support that is distance

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

## This note was uploaded on 08/22/2011 for the course ENG 48331 taught by Professor Brown during the Three '11 term at University of Technology, Sydney.

### Page1 / 2

File Assignment2.pdf - ASSIGNMENT NO.2 Assignment problem...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online