File Assignment7.pdf

# File Assignment7.pdf - the figure Assignment problem #3 (20...

This preview shows pages 1–2. Sign up to view the full content.

ASSIGNMENT NO.7 Assignment problem #1 (20 out of 100) The circular shaft shown in the figure is made of a material that can carry a maximum allowable shear stress of 60MPa. The shear modulus of the material is G=80GPa. Under the maximum allowable torque applied at point D find the twisting angle at point D. Note that between A and B the section is hollow. Assignment problem #2 (20 out of 100) Find the shear centre of the thin-walled section shown in

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: the figure Assignment problem #3 (20 out of 100) Find the principal stresses and draw the Mohrs circle. Assignment problem #4 (20 out of 100) Calculate the plastic moment of the section. Calculate the yield moment of the section. Calculate the shape factor. Assignment problem #5 (20 out of 100) Find the deflection at the tip of the beam using the strain energy. EI =65kNm 2 3m A B C 2m 589N...
View Full Document

## This note was uploaded on 08/22/2011 for the course ENG 48331 taught by Professor Brown during the Three '11 term at University of Technology, Sydney.

### Page1 / 2

File Assignment7.pdf - the figure Assignment problem #3 (20...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online