File Assignment7_Solutions.pdf

# File Assignment7_Solutions.pdf - ASSIGNMENT NO.7 Assignment...

This preview shows pages 1–3. Sign up to view the full content.

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: ASSIGNMENT NO.7 Assignment problem #1 (20 out of 100) The circular shaft shown in the figure is made of a material that can carry a maximum allowable shear stress of 60MPa. The shear modulus of the material is G=80GPa. Under the maximum allowable torque applied at point D find the twisting angle at point D. Note that between A and B the section is hollow. Solution For region AB ( ) 4 4 4 4 50 35 749.5 10 2 J mm = = (1pts) max 60 c T MPa J = = Allowable torque 4 6 max 60 749.5 10 8.95 10 8.95 50 J T Nmm kNm c = = = = (3pts) For region BC ( ) 4 4 4 50 981.3 10 2 J mm = = (1pts) max 60 c T MPa J = = Allowable torque 4 6 max 60 981.3 10 11.78 10 11.78 50 J T Nmm kNm c = = = = (3pts) For region CD ( ) 4 4 4 40 401.9 10 2 J mm = = (1pts) max 60 c T MPa J = = Allowable torque 4 6 max 60 401.9 10 6.03 10 6.03 40 J T Nmm kNm c = = = = (3pts) The allowable torque is 6.03kNm since it is the minimum value among the three regions. (3pts) 6 6 6 3 4 3 4 3 4 1 6.03 10 400 6.03 10 100 6.03 10 500 1.42 80 10 749.5 10 80 10 981.3 10 80 10 401.9 10 n i i i i i T L rad G J = = = + + = (5pts) Assignment problem #2 (20 out of 100) Find the shear centre of the thin-walled section in the figure...
View Full Document

## This note was uploaded on 08/22/2011 for the course ENG 48331 taught by Professor Brown during the Three '11 term at University of Technology, Sydney.

### Page1 / 6

File Assignment7_Solutions.pdf - ASSIGNMENT NO.7 Assignment...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online