> REPLACE THIS LINE WITH YOUR PAPER IDENTIFICATION NUMBER (DOUBLE-CLICK HERE TO EDIT) <
—These instructions give you guidelines for
preparing papers for IEEE TRANSACTIONS and JOURNALS
Use this document as a template if you are using Microsoft
6.0 or later. Otherwise, use this document as an
instruction set. The electronic file of your paper will be
formatted further at IEEE. Define all symbols used in the
abstract. Do not cite references in the abstract. Do not delete
the blank line immediately above the abstract; it sets the
footnote at the bottom of this column.
—About four key words or phrases in
alphabetical order, separated by commas. For a list of
suggested keywords, send a blank e-mail to
HIS document is a template for Microsoft
6.0 or later. If you are reading a paper or PDF version of
this document, please download the electronic file,
TRANS-JOUR.DOC, from the IEEE Web site at
so you can use it to prepare your manuscript. If you would
prefer to use LATEX, download IEEE’s LATEX style and
sample files from the same Web page. Use these LATEX
files for formatting, but please follow the instructions in
TRANS-JOUR.DOC or TRANS-JOUR.PDF.
If your paper is intended for a
your conference editor concerning acceptable word processor
formats for your particular conference.
When you open TRANS-JOUR.DOC, select “Page
Layout” from the “View” menu in the menu bar (View | Page
which allows you to see the footnotes. Then, type over
Manuscript received October 9, 2001. (Write the date on which you
submitted your paper for review.) This work was supported in part by the U.S.
Department of Commerce under Grant BS123456 (sponsor and financial
support acknowledgment goes here). Paper titles should be written in
uppercase and lowercase letters, not all uppercase. Avoid writing long
formulas with subscripts in the title; short formulas that identify the elements
are fine (e.g., "Nd–Fe–B"). Do not write “(Invited)” in the title. Full names of
authors are preferred in the author field, but are not required. Put a space
between authors’ initials.
F. A. Author is with the National Institute of Standards and Technology,
Boulder, CO 80305 USA (corresponding author to provide phone: 303-555-
5555; fax: 303-555-5555; e-mail: author@ boulder.nist.gov).
S. B. Author, Jr., was with Rice University, Houston, TX 77005 USA. He
is now with the Department of Physics, Colorado State University, Fort
Collins, CO 80523 USA (e-mail: email@example.com).
T. C. Author is with the Electrical Engineering Department, University of