CIS403_Extended_ACL_Lab

CIS403_Extended_ACL_Lab - CIS403 - Configuring Extended...

Info iconThis preview shows pages 1–3. Sign up to view the full content.

View Full Document Right Arrow Icon
CIS403 - Configuring Extended Access Lists Objective Configure, and apply an extended ACL to permit or deny specific traffic. Test the ACL to determine if the desired results were achieved. Background/Preparation Cable a network similar to the one in the diagram. Any router that meets the interface requirements displayed on the above diagram, such as 800, 1600, 1700, 2500, 2600 routers, or a combination, may be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced from 1721 series routers. Any other router used may produce a slightly different output. The following steps are intended to be executed on each router unless specifically instructed otherwise. Start a HyperTerminal session as performed in the Establishing a HyperTerminal session lab. Step 1: Configure the hostname and passwords on the routers a. On router 1, enter the global configuration mode and configure the hostname as shown in the chart. Then configure the console, virtual terminal and enable
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
passwords. Configure the FastEthernet and Serial interfaces. S0 = 192.168.16.1 b. On router 2, enter the global configuration mode and configure the hostname as shown in the chart. Then configure the console, virtual terminal and enable passwords. Configure the FastEthernet and Serial interfaces. S0 = 192.168.16.2 Step 2: Configure the hosts on the Ethernet segments a. PC 1 IP address 192.168.14.2
Background image of page 2
Image of page 3
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 09/09/2011 for the course CIS CIS403 taught by Professor Mr.t during the Spring '11 term at ECPI College of Technology.

Page1 / 9

CIS403_Extended_ACL_Lab - CIS403 - Configuring Extended...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online