UNIVERSITY OF UTAH ELECTRICAL AND COMPUTER ENGINEERING DEPARTMENT ECE 3110 SPICE ASSIGNMENT #1 COMMON-EMITTER AMPLIFIER CHARACTERISTICS AssignmentThe purpose of this assignment is to learn SPICE simulation techniques, but more importantly to prepare you for Lab 2. The values from this assignment will be compared to the measurements in Lab 2. You should complete the simulations before attempting the lab measurements. This will help you know what to look for and expect in Lab 2. Hopefully this will make your time in lab more efficient and allow you to learn more. Create a PSPICE schematic for the following circuit. The model for the 2N3904 transistor is available in PSPICE. Fig. 1. Single stage common-emitter bipolar voltage amplifier. 1.Set VCC = +10 Volts and simulate the DC operating point. Report the node voltages of the base, collector, and emitter. 2.Apply a transient sinusoidal source at 10kHz to the input. Run a transient simulation and find the highest input voltage that doesn’t give visible distortion on the output.