Flow Meter Calibration Rig - AhmedAlsogher 971952...

Info iconThis preview shows pages 1–6. Sign up to view the full content.

View Full Document Right Arrow Icon
                                                      Flow Meter Calibration Rig Ahmed Alsogher 971952
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
    Introduction Objective: to measure the flow rates in  pipe or channels. Three Meters: Pitot Tube Orifice Plate Venturi
Background image of page 2
    Experimental Procedure Fill the pump tank water. Connect the manometer to selected  flowmeter Opening or closing clips. Start the pump against a closed discharge  valve Slowly open valve and set the flow rate. Each flowmeter take 5 readings at different  flow At same time record manometer readings. Flow rates are measured by timing level rise  in the calibration tank.
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
    Raw Data A table showing all experimental data: Run number flowrate Manometer reading Reynolds number Pitot tube Q , velocity Orifice Q  Venturi Q
Background image of page 4
    Raw Data  (continued) The experimental data are then used to 
Background image of page 5

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 6
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 09/27/2011 for the course CHEMICAL E CHE 309 taught by Professor M.elgaily during the Fall '09 term at King Fahd University of Petroleum & Minerals.

Page1 / 19

Flow Meter Calibration Rig - AhmedAlsogher 971952...

This preview shows document pages 1 - 6. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online