hwold2 - AE383 System Dynamics HW#2 Due: November 24, 2005...

Info iconThis preview shows pages 1–3. Sign up to view the full content.

View Full Document Right Arrow Icon
1 of 1 AE383 System Dynamics HW#2 Due: November 24, 2005 1. Write the equations of the two-tank system depicted below. The restrictions at A, B, and C are of same type and same diameter, The flow rate through the restrictions is proportional square root law of the pressure difference. In addition, when 2 30 cm h = , the outflow from restriction C is 300 g/min. 2. A scheme for the position control of a load with a permanent magnet DC motor is sketched below. The gear ratio is given to be :1 N . Obtain the governing equations for this dynamic system and sketch its block diagram. 3. Obtain the model of the dashpot given below, where y is the input and z is the output. Neglect the inertias and assume that the flow through the restriction is directly proportional to the pressure difference.
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
2 of 2 4. Model the hydraulic system given below. Neglect the inertias and assume that flow through the restrictions is proportional to the pressure difference.
Background image of page 2
Background image of page 3
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 10/24/2011 for the course AEE 463 taught by Professor Melin during the Spring '11 term at Middle East Technical University.

Page1 / 3

hwold2 - AE383 System Dynamics HW#2 Due: November 24, 2005...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online