lab3 - Objective: Learn to use LABVIEW software. 1. Using...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon
Objective: Learn to use LABVIEW software. 1. Using the Labview software, design a 0-10 volt power supply and output the voltage on AC-1 output channel as shown in fig 1. 2. Using the LABVIEW software, design a 0-10 volt voltmeter and input the power supply voltage on AC-4 input channel. 3. Connect the AC-1 output channel to the AC-4 input channel on the LABVIEW DAQ board. 4. Run the program. The voltmeter should read the power supply voltage. Design a temperature sensing system using LABVIEW software. 1. Measure the temperature output of the LM34 sensor. 2. Use the LABVIEW software and the input channel on the DAQ board to display this temperature. 3. Compare the temperature output at the LM34 sensor with a predetermined temperature using LABVIEW software. 4. If the temperature at the LM34 sensor rises above this predetermined temperature, a 5V signal should appear at the AC-0 output channel on the DAQ board.
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 2
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 10/24/2011 for the course ELET 3700 taught by Professor Grubb during the Spring '11 term at North Texas.

Page1 / 3

lab3 - Objective: Learn to use LABVIEW software. 1. Using...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online