lab 4 report

# lab 4 report - ELET 3740 Lab4: Circuit Design Using Op Amps...

This preview shows pages 1–3. Sign up to view the full content.

ELET 3740 Lab4: Circuit Design Using Op Amps Objective 1. Design a circuit to implement a given output equation. 2. Simulate the design for accuracy. 3. Implement the design in hardware. 4. Contrast and compare simulated and actual results. Problem Statement Design and implement an op-amp circuit to implement the following output equation. V 0 =2(V 1 -V 2 ) +V 3 Use no more than two op amps in your design. Diagram Procedure Part 1: Circuit Design and Simulation

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Design your circuit based upon your knowledge of the basic op amp configurations studied to date. Pick some simple inputs and predict what the circuit output should be. These inputs should be one you can easily duplicate in Part2. At least one of the inputs should be a small ac signal. Simulate the circuit in B 2 Spice or Multisim to verify its theoretical accuracy. Show plots verifying your circuit implements the desired output equation.
This is the end of the preview. Sign up to access the rest of the document.

## This note was uploaded on 10/24/2011 for the course ELET 3720 taught by Professor Hayes during the Spring '08 term at North Texas.

### Page1 / 3

lab 4 report - ELET 3740 Lab4: Circuit Design Using Op Amps...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online