Inductor Tech MEmo

Inductor Tech MEmo - Page 1 of 3 Memorandum October 12,...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon
Page 1 of 3 Memorandum October 12, 2011 For : ELCT 301 From : Meredith Thomas Email : thoma242@email.sc.edu Subject : Inductor Design ______________________________________________________________________ The purpose of this lab was to design a 100μH inductor with a 3A current capability using an EFD 30 ferrite ceramic core material for operation frequency at 100 kHz. The maximum flux density used is 0.25T. For the prelab, I had to calculate the wire gauge to withstand the frequency and current specifications. I then calculated the number of turns I would need to achieve an inductance of 100μH. Next, I calculated the reluctance of the air gap as well as the reluctance of the material. Finally, I was to measure the AC and DC resistance of the inductor at 100 kHz and 1 MHz (See Appendix for all calculations). Equation (1) of the Appendix was used to calculate most of these values. Using Equations (7) and (8), I found the reluctance of the air gap to be significantly higher than the reluctance of the material, by about 2 orders of magnitude. Therefore I was able to
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Image of page 2
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 10/25/2011 for the course ELCT 301 taught by Professor Santi during the Spring '09 term at South Carolina.

Page1 / 3

Inductor Tech MEmo - Page 1 of 3 Memorandum October 12,...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online