final project

final project - 12-2-08CES 102-028Lauren KaszakCaroline...

Info iconThis preview shows pages 1–2. Sign up to view the full content.

View Full Document Right Arrow Icon

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
This is the end of the preview. Sign up to access the rest of the document.

Unformatted text preview: 12-2-08CES 102-028Lauren KaszakCaroline ChristGoran RacBen RaineyReid CabinessPhase I of the project called for a device being built that would measure and/or set the tension on a wire. A guitar string was used as a wire for this project. Instructions for assembling a desired device, using the device to gather the desired data, and performing the necessary calculations to obtain either tension on the wire or distance from the fulcrum are shown below.Instructions for Replications of Device1.Create the base with a sturdy piece of wood. Drill two holes on each side of the beam a couple of inches from the end. 2.Take two more pieces of wood and bolt them into the holes on either side of the base so that they are standing straight up, perpendicular to both the base and the floor. These are the sides of the device.3.Drill a hole at the top of each side directly across from each other. 4.Using another piece of wood that is at least seventy-five centimeters long, drill two holes on each side, five centimeters from the end. Also, screw a nail into the end of the beam closest to the side holes. This piece of Also, screw a nail into the end of the beam closest to the side holes....
View Full Document

This note was uploaded on 11/03/2011 for the course CHE 234 taught by Professor Smith during the Spring '11 term at Clemson.

Page1 / 3

final project - 12-2-08CES 102-028Lauren KaszakCaroline...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online