Truss_Test_Preview (3)

Truss_Test_Preview (3) - Truss Testing Preview ENGR 111 -...

Info iconThis preview shows pages 1–5. Sign up to view the full content.

View Full Document Right Arrow Icon
Truss Testing Preview ENGR 111 - Track A Load arm Base Pivot block Counter weight Load pin Load weight Pivot point d L Truss Buster Rig Grommets
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Truss Tester Components grommets Load plate and load pin pads Load arm Screws to adjust load arm
Background image of page 2
Load arm Base Pivot block Counter weight Load pin Load weight Pivot point d L Truss Buster Rig Grommets The Test 1) Raise and level load arm. 2) Insert truss. 3) Place grommets on load points. Should be as close to center of truss as possible. 4) Place load plate on grommets. 5) Lower load arm to contact load pin. NOTE that the arm is parallel to the surface. 6) Apply weight to load arm just above load pin. 7) Roll weight out along load arm. 8) Note position of weight on failure. grommets Load arm weight
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Class length 110 minutes, 15 minutes front and back for administrative work leaves 95 minutes. 4 testers for 24 teams provides about 15 minutes/team to conduct the tests. Teams should be able to conduct test and collect
Background image of page 4
Image of page 5
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 11/08/2011 for the course ENGR 111 A taught by Professor Reddy during the Spring '10 term at Texas A&M.

Page1 / 12

Truss_Test_Preview (3) - Truss Testing Preview ENGR 111 -...

This preview shows document pages 1 - 5. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online