1.1.7-lab---basic-switch-configuration-1_CESAR_RIOS_MORALES.pdf

This preview shows page 1 - 3 out of 12 pages.

© 2013 - 2019 Cisco and/or its af f iliates. All rights reserved. Cisco Public Page 1 of 11 w w w.netacad.com Lab - Basic Switch Configuration Nombre: Cesar Jesus Rios Morales Topology Addressing Table Dev i ce I nterface IP Address / Pref i x S1 VLAN 99 192.168.1.2 / 24 2001:db8:acad::2 / 64 f e80 :: 2 PC-A N I C 192.168.1.10 / 24 2001:db8:acad:3 / 64 f e80 :: 3 Objectives Part 1: Cable the Network and Verify the Default Switch Conf i gurat i on Part 2: Configure Basic Network Device Sett i ngs Configure basic switch se tt ings . Configure the PC IP address . Part 3: Verify and Test Network Connect i v i ty Display device con f igura t ion . Test end-to-end connectivity with ping . Test remote management capabilities with Telne t. Part 4: Manage the MAC Address Tab l e Record the MAC address of the hos t. Determine the MAC addresses that the switch has learned . List the show mac address-table command op t ions . Set up a static MAC address .
© 2013 - 2019 Cisco and/or its af f iliates. All rights reserved. Cisco Public Page 2 of 11 w w w.netacad.com Lab - Basic Switch Conf i gurat i on Background / Scenario Cisco switches can be configured with a special IP address known as the switch virtual interface (SVI). The SVI, or management address, can be used for remote access to the switch to display or configure settings. If the VLAN 1 SVI is assigned an IP addres s, by default all ports in VLAN 1 have access to the SVI IP address . In this lab, you will build a simple topology using Ethernet LAN cabling and access a Cisco switch using t he console and remote access methods. You will examine default switch configurations before configuring basic switch settings. These basic switch settings include device name, interface description, local passwords , message of the day (MOTD) banner, IP addressing, and static MAC address. You will also demonstrate t he use of a management IP address for remote switch management. The topology consists of one switch and one host using only Ethernet and console por t s . Note : The switches used are Cisco Catalyst 2960s with Cisco IOS Release 15.2(2) (lanbasek9 image). O t her switches and Cisco IOS versions can be used. Depending on the model and Cisco IOS version, t he commands available and output produced might vary from what is shown in t h e labs . Note : Make sure that the switches have been erased and have no startup configurations. If you are unsure , contact your instructor. Refer to Appendix A for the procedures to initialize and reload a swi t ch . The default bias template used by the Switch Database Manager (SDM) does not provide IPv6 address capabilities. Verify that SDM is using either the dual-ipv4-and-ipv6 template or the l anbase -rout i ng template. The new template will be used after reboot even if the configuration is not saved . S1# show sdm prefer Use the following commands to assign the dual-ipv4-and-ipv6 template as the default SDM t empla t e . S1# configure terminal S1(config)# sdm prefer dual-ipv4-and-ipv6 default S1(config)# end S1# reload Required Resources 1 Switch (Cisco 2960 with Cisco IOS Release 15.2(2) lanbasek9 image or comparable)

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture

  • Left Quote Icon

    Student Picture