Lecture 19_supplement-1

# Lecture 19_supplement-1 - Lecture 19_supplement Lecture 19...

This preview shows pages 1–3. Sign up to view the full content.

Lecture 19_supplement Page 1 Lecture 19 supplement Label each of the following transfer functions as either a low-pass, band-pass, or high-pass filter? (15 points)      1 2 3 10 10 11 0 0 100 1 100 2000 1 20 100 out in out in out in Vs s Hs s s s s s s s s s   H 1 = pole at -1, zero at -10, pole at -100 = low-pass H 2 =zero at 0, pole at -1, pole at -100 = band-pass H 3 =zero at 0, zero at -1, pole at -20, pole at -100 = high-pass

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
Lecture 19_supplement Page 2 Problem 2: You need to design a Non-Inverting Amplifier using one of the two following Op-Amps. a) Which Op-Amp should you use in your design if you want your output to have the largest amplitude possible without distortion or amplitude reduction due to the frequency limit of the Op-Amp and your input is  6 0.1sin 2 10 in vt tV  ? You must justify your answers and give the maximum amplitude of the resulting output voltage waveform.
This is the end of the preview. Sign up to access the rest of the document.

## This note was uploaded on 11/08/2011 for the course EE 230 taught by Professor Mina during the Winter '08 term at Iowa State.

### Page1 / 12

Lecture 19_supplement-1 - Lecture 19_supplement Lecture 19...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online