lecture9-part1 - EEL 4744C: Microprocessor Applications...

Info iconThis preview shows pages 1–9. Sign up to view the full content.

View Full Document Right Arrow Icon
Dr. Tao Li EEL 4744C: Microprocessor Applications Lecture 9 Part 1 Serial I/O
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Dr. Tao Li Reading Assignment
Background image of page 2
Dr. Tao Li Disadvantage of parallel I/O is wire needed for each bit, cable bulky, expensive, and susceptible to reflections and induced noise leading to limit of short distances Serial I/O sends 1 bit @ a time, reducing cost, transmission line effects, and noise problems Basic serial comm. system Introduction
Background image of page 3

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Dr. Tao Li UART: u niversal a synchronous r eceiver/t ransmitter UART design issues: data coding, order of bits sent, synchronous between transmitter and receiver, data rate, electrical signals for logic values, and handshaking Introduction
Background image of page 4
Dr. Tao Li Any data code agreeable to both ends will work (e.g. ASCII) Two choices for transmission order, UARTs typically send LSB of data first Data sent asynchronously , i.e. sent at any time, not synchronized with any process Data rate specified in bits/second (e.g. baud rate) Data Coding and Transmission ‘M’: 1001101
Background image of page 5

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Dr. Tao Li Define interface between 2 UARTs Standards needed to allow different vendor devices to work Key elements defined: Handshaking signals Signal flow direction Communication device types Connectors and interface mechanical issues Electrical signal levels Standards for Serial I/O Interface
Background image of page 6
Dr. Tao Li Most common standard is RS-232-C Signals in RS-232 interface other than for transmitted and received data are for handshaking 3 ways data can be sent in serial (simplex, half-duplex, and full-duplex) Standards for Serial I/O Interface
Background image of page 7

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Dr. Tao Li
Background image of page 8
Image of page 9
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 11/13/2011 for the course EEL 4744c taught by Professor Staff during the Fall '09 term at University of Florida.

Page1 / 25

lecture9-part1 - EEL 4744C: Microprocessor Applications...

This preview shows document pages 1 - 9. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online