This preview shows page 1. Sign up to view the full content.
Unformatted text preview: ge change the volume units to m3. Select the Set Vol. Flow radio button and enter 2,000 L/batch, since this is the capacity of our reactor. Click OK to save the changes and close the stream input window. 15) Double click on the reactor to add the operating procedures. Add the operations Charge, Heat, React (kinetic), and Transfer‐out. Click OK to close. 16) Right click the reactor and select Operation Data CHARGE‐1 (Charge). 17) Charge‐1: Feed a. Under the Operating Conditions tab, charge using the S‐101 stream with a volume of 2,000 L, no setup time, and a process time calculated based on a volumetric flow rate of 2 m3/s. at the bottom of the input sheet to go b. Click the next button to the next operation. 18) HEAT‐1 a. Enter a final temperature of 350 K. The default heating utility is 90% efficient steam with a heat rate of 1 °C/min. For this simulation, we will use the default heating values. b. Click the next...
View Full Document
This note was uploaded on 11/14/2011 for the course CHEN 4520 taught by Professor Wiemer during the Fall '11 term at Colorado.
- Fall '11