ECE 2140 Experiment 9 (1)

ECE 2140 Experiment 9 (1) - Joshua Dean Berk Bozoklar, Eric...

Info iconThis preview shows pages 1–3. Sign up to view the full content.

View Full Document Right Arrow Icon
Joshua Dean Berk Bozoklar, Eric Herrera Experiment 9 J-K Flip Flop February 23, 2011 The George Washington University School of Engineering and Applied Science ECE 2140 Design of Logic Systems Lab Section 32 Jie Chen AND and OR Gates Joshua Dean ECE 2140 1
Background image of page 1

Info iconThis preview has intentionally blurred sections. Sign up to view the full version.

View Full DocumentRight Arrow Icon
Abstract: This lab provides an introduction to Digital Logic Systems by using a J-K flip-flop, Power Supply, Digital Voltmeter and. Introduction: The purpose of this experiment was to build a circuit that verifies the given truth table. Our group connected the clock from the function generator to the J-K flip-flop, and measured the transition characteristics of the J-K flip-flop in order to check the results. Equipment: 1 TTL J-K Flip Flop (7476) 1 BCD-to-7 segment. Decoder (7448) Power Supply Digital Multimeter Function Generator Breadboard Method: From the ECE Lab website, TTL J-K Flip Flop (7476) data sheets were downloaded. The purpose of downloading the data sheet was to find the location of the I/O pins, Vcc, and ground. The data sheet was also used to find the absolute maximum voltages, which each pin could
Background image of page 2
Image of page 3
This is the end of the preview. Sign up to access the rest of the document.

This note was uploaded on 11/14/2011 for the course ECE 2140 taught by Professor Carrol during the Spring '11 term at GWU.

Page1 / 3

ECE 2140 Experiment 9 (1) - Joshua Dean Berk Bozoklar, Eric...

This preview shows document pages 1 - 3. Sign up to view the full document.

View Full Document Right Arrow Icon
Ask a homework question - tutors are online