{[ promptMessage ]}

Bookmark it

{[ promptMessage ]}

Physics II workshop_Part_40

# Physics II workshop_Part_40 - Work done in lifting a block...

This preview shows pages 1–2. Sign up to view the full content.

82 Work done in lifting a block Equipment: Motion sensor, force sensor, LabPro, laptop, mass set, cage. Part 1: Predictions Imagine you are holding a block of mass 2 kg initially at rest. You then pull upwards, lifting the block by 50 or 60 cm, and end with the block again at rest . 1. Sketch your predictions for the position ( y ), velocity ( v ) and lifting force ( F ) versus time. 2. Make a prediction for the change in kinetic energy of the block. t y t v t F

This preview has intentionally blurred sections. Sign up to view the full version.

View Full Document
83 Part 2: Experiment Set-up and calibration First locate and load the experiment file lift_block . To locate the file go to My Computer > Student Shares on svphy01 > University Physics Students > Team Physics 311 > Lab Pro. Connect the Labpro to the computer, a motion sensor to Dig/Sonic 1 and a force sensor to CH1. Be sure that the force sensor is switched to the 50 N setting. Place the motion sensor on the floor with the protective cage over it . Double-click the file to start
This is the end of the preview. Sign up to access the rest of the document.

{[ snackBarMessage ]}

### Page1 / 2

Physics II workshop_Part_40 - Work done in lifting a block...

This preview shows document pages 1 - 2. Sign up to view the full document.

View Full Document
Ask a homework question - tutors are online